Case to store games for Nintendo Switch.
This case is a friction fit design so no extra parts will be needed to hold the case shut. Just press it shut, and it will stay closed until you pull it apart again. It can fit 16 cartridges and once closed the cartridges will not move from the slots. Slots for the cartridges have enough clearance that they are not damaging the cartridge, but also not letting them rattle around too much.
Depending on the tolerances of your specific printer, the z-seam may need to be sanded down or worked a little to get the friction fit rim to slide nicely. I have not had to sand any that I have printed, but some I did have to move the top on and off a couple times for them to slide nicely. If your clearance seems tight around where the z-seam is, I recommend trying this method before trying to sand the z-seam down.
Dimensions are approximately: 70.8mm x 60.3mm x 37.5mm
Change Log:
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (498)