Egg - Saver by laisch

laisch

Household>Other House Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

Standard

Designer

1.3 h

1 plate

4.6(11)

Open in Bambu Studio

Boost

105

Released

Description

Now you can transport your delicous egg without the fear of crushing it!

Printing:

This is a print in place model.
Activate supports, but block it on all the hinges, otherwise they can bind up.

Postprocessing:

Remove the supports and clean up the little tabs on the buckles.

Comment & Rating (17)

@wikitinl2

tried this print 3x, every time, same issue on the tab exactly the same

The designer has replied

@laisch

Hi, seems like there is some problem with bed adhesion and the clip got knocked over during the print. I had the same issue on the first iteration, that's why I added these sacrificial tabs to give it more surface for the bed since I wanted to avoid a brim. You can still try it with a brim, but you have to clean up more afterwards.

@robjohna

Same issue here. Weird tab printed offset. Same tab on two occasions. Otherwise it's a great conceptual design.

@tomchak

Boosted

Great print, no issues at all. The hinge seems a bit delicate but time will tell if that's the case. Thank you for sharing your model. Boosted!

The designer has replied

@laisch

Thx 👍

@urielUMJ

Print Profile

Standard

Muy bien, pero lo mejor es un poco demasiado pequeño para que el huevo capa ya que cuando lo pones dentro no se cierra bien la tapa y está diseñado para huevos muy pequeños haría algún diseño para huevos más grandes también pero en general está chulo para hacer algún experimento pero no no creas que vayas a dar mucho al huevo jajajajaja

@PenguinGod

Print Profile

Standard

Good for easter hunts

@Kirdae

Boosted

very nice model!

@DaCa86

Print Profile

Standard

Ich habe 2 Eier gleichzeitig gedruckt und bei beiden das Problem, dass das kleine Teil zum einrasten, nicht richtig gehaftet hat und sich leicht verschoben hat.