Recently, 

I started to be interested in mecha-style designs. 

When I saw this bottle of water on my desk, 

I thought about how to decorate it. 

After a few days of trying, 

I got this:

Printing and assembly instructions:

Additional Note 1

The printing details are not perfect

Additional Note 2

There are many supports

And it is difficult to install

Patience and a little strength are required

Additional Note 3

This model was designed with only Bambu PLA for testing

Other filament have not been tried yet

There may be a certain tolerance

Especially the position of the bottle cap

This model is currently available in 32.4/32.6 specifications of the bottle cap

Please leave a message if you have other needs

Bambu PLA test 32.4 will be tighter, and it takes a little force when installing, but it will not slide at all

Bambu PLA test 32.6 will be slightly loose, easier to install, but it will slide slightly after tightening

The default in the plate is 32.4, and 32.6 is outside the plate

Additional Note 4

The metal filament in the picture are Bambu PLA Silk+

Must bring +

Bring +

+

Otherwise it will break during installation

The narrow side of the hollowed-out is the top

The wide side is the bottom

Slowly insert the middle section into the base

You can gently press the bottom of the middle section

to make it fit into place

After connecting the middle section and the base, insert the water bottle

When it reaches the base, you need to rotate the water bottle to get it into place accurately

The top installation is similar to the base

Lightly press the middle section and gently rotate the top to put it into place

Press the cover into the connecting ring

Insert the connecting ring sideways into the track and rotate it to the correct direction

Apply some force

Press the bottle cap into the top cover

Done

Good luck!