This is Large Model and will take the better part of a day on most printers

Print Settings:

• Layer Height - 0.28mm
• Lightning Infill 20%+
  • (Very important, using regular infill increases filament usage and time to print significantly)
• 2 walls

Other Notes about Printing

• Highly recommend using a glue stick to hold the print to the build plate
• Print the lid and base separately

Magnetic Lid

• Uses (14) 6mm (width) x 2mm (depth) magnets
• Superglue the magnets into the holes
• May require some force to get the magnets into the holes, the holes are slightly bigger than 6mm

Details:

• Tower is large (150mm x 150mm x 150mm)
• Lid covers the dice holes allowing for easier transport
• 60+ standard sized dice can fit in the slots.
• Dice can be no bigger than 22mm and cannot be smaller than 12.7mm. This should be fine for almost all dice and more than fine for standard (14mm - 16mm diameter) dice
• Dice tower rolls your dice and then deposits them into a dish at the bottom of the tower
• A DND Logo is engraved into the front wall of the tower (not pictured in the render)
• Dice tower should fit almost all dice and is designed to fit standard sized dice