Color swatch holder

This design is based on my earlier print-in-place box. This box is made to accomodate the Bambulab Color Swatch palette, in the well-known ML Design aesthetics. ( for the rest of the lineup check out my uploads )

THINGS TO KEEP IN MIND:

• Before printing make sure that the bed is cleaned properly, the filament is dry and calibrated. Missing these could result a bad print quality or failure.
• When closing the latch, it reaches is designated ‘closed’ state by deforming. If you choose to print it from a more rigid material you might need to file it to reach perfect closing. If you print it from a more flexible material like PETG, your print should work without any filing. If you find closing difficult, file the surface shown below.

If you are printing the models on non-Bambulab printers please bare in mind the following:

• Use support at the bottom part of the lock, at the inner cavity of the small enclosures lock and at the logo seating
• Prevent using any support on the hinges and on the hinge of the lock.
• Increase infill at the hinge section and its close proximity.

In case you have any feedback, feel free to share. 
Im curious to see what you make of the model. If you print one please post a photo of it as an inspiration for others.