Silicagel shoes dryer by Gintrius

Gintrius

Household>Other House Models

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

3.4 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Silicagel shoes dryer

Print 3D parts;
Fill up with silicagel or silicagel kitty litter;
Join parts. Press until you hear a click;
Use inside of shoes when get wet.

Comment & Rating (5)

@user_3755855874

The print profile is no longer public

The supports were extremely difficult to remove, resulting in a broken closing tooth. Furthermore, I imagine that once closed, it's permanent

Show original

@RickRock53

The first print failed because the attachments detached along with the supports, we'll see about the second one. Overall, the concept is excellent, and the other parts turned out beautifully

Show original

@Astara

The print profile is no longer public

Support Issue:the supports are very hard to remove, the model should be updated to optimize them. probably needs at least use tree supports if not manual painting or pla support material

Strength Issue:edit: moving down to 2 stars, after removing all the supports and doing a quick test fit it was impossible to reopen the piece without breaking it. 5 clips snapped. it actually still closes with only 2 full clips left that were right next to each other. half the clips could probably be removed to make opening it back to easier

The designer has replied