Dummy 13 - TPU ball joints for version 1.0 Remixed by sla.studio

Remixed by

sla.studio

Toys & Games>Characters

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

All parts

Designer

1.7 h

3 plates

1.0(1)

Open in Bambu Studio

Boost

123

104

Released

Description

Remixed inner frame of the 1.0 model to use TPU ball joints. This results in a stiffer model that's less prone to sagging or loosening over time. The frame parts are printed with pegs that the TPU balls press onto. It is compatible with Dummy 13 V1.0 parts and armor.

I used Bambu PETG HF for the frame and Siraya Tech 85A TPU for the balls.

Re-implemented from scratch for the 1.0 models based on luu0898's model.

Boost Me (for free)

If you like my models, I would appreciate a boost!

Plate 1 - PETG Frame

Layer Height: 0.10mm recommended
Orientation: follow print instructions for the original Dummy 13.
Supports: manually paint supports onto the floating pegs. Auto-supports will work, but it'll add supports in unnecessary regions.

Plate 2 - TPU Balls

Layer Height: 0.10mm recommended
Orientation: the balls have a flat section that should be on the print bed.
Supports: none

Plate 3 - PETG Frame, feminine chest

Same instructions as Plate 1 if you're using the official Dummy 13 - feminine torso parts.

Comment & Rating (9)

@luu0898

Is this a copy of mine? You should give credit

The designer has replied

Show original

@slastudio

this was re-implemented from scratch to fit the 1.0 models. i was inspired by your older model before you had the 1.0 model available, and i'll adjust the description to reflect that.

@Fabter

Not everything is a copy lol. You asked for money to "buy the files" but the files are free you're just money hungry...

@RiHi36

Boosted

thx

@RB87

how the heck do I assemble this thing

@user_1431129108

Boosted

boost comment?, please see my comment above/below for review

(Edited)

@user_1431129108

Boosted

assembled 1, PETG+TPU Good : TPU works, joints are exactly how i hoped. some feedback : I thought i wouldnt need glue after seeing the indentation at the end of pegs, however that was not case (atleast for me). They pop out when rotated without glue. With glue they are perfect. Maybe indentation helped with better adhesion? Overall good model, thanks for sharing mate! boosted.

(Edited)

@nvisble

Print Profile

All parts

Other Issues:The TPU ball joints didn't fit into the pegs. Bent just about every single one before splitting the TPU balls.

@slastudio

have you calibrated your filament flow rates? the joints have to be a very tight fit, otherwise the figure will fall apart. because of that, the TPU and PETG filaments have to be pretty dialed in.

No more