Better Spool Holder for IKEA Skadis Pegboard by TamasK

TamasK

Tools>Organizers

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

PLA/PETG - 0.4mm nozzle, 0.2mm layer, 3 walls, 15% infill

Designer

2.8 h

1 plate

4.9(11)

PLA - 0.6mm nozzle, 0.3mm layer, 2 walls, 20% infill

Designer

1.7 h

1 plate

5.0(1)

PETG - 0.6mm nozzle, 0.3mm layer, 2 walls, 20% infill

Designer

1.7 h

1 plate

Open in Bambu Studio

Boost

218

578

160

Released

Description

This is a basic spool holder for IKEA Skadis pegboards.
I've found that the other designs on here are either way too flimsy or waste quite a bit of material.
This design attempts to be the best of both worlds; remaining as light as possible while strong enough to hold full spools of filament.

STRONG, LIGHT, EFFICIENT, STURDY
Prints under 100g / set.
No other materials/parts required
Easy assembly, prints in two halves. (can use glue to permanently bond the two if you wish)
ONLY HAS ONE SET OF PEGS BY DESIGN! (weight, waste & simplicity..etc.)
Each spool bracket holds 1 spool of filament
1 Skadis Baord (22"x22" / 56cm x 56cm) can fit 18 spools [up to 21 if you don't mind a little overhang]

Bill of Materials

Bambu Filaments

Black

A00-K0-1.75-1000-SPLFREE

× 1

White

G02-W0-1.75-1000-SPLFREE

× 1

Buy Now

Download BOM

Comment & Rating (22)

@pinepicker

Print Profile

PLA/PETG - 0.4mm nozzle, 0.2mm layer, 3 walls, 15% infill

Excellent profile, supremely stable

Show original

@Steckdosenau.to

Hello, I would like to use your model, but I don't want to glue it. Can you also create it as 1 part?

The designer has replied

@tamask

Have you tried printing it? It is quite a snug fit, especially if you have multiples side by side. Printing it in one piece would be very wasteful and require lots of supports. I have not actually needed glue on any of my prints.