I wanted a towel hanger for in the kitchen but also be able to hang my kitchen gloves.

Make sure to print the test variant first to check the tollerances.

Also make sure you have towels with large loops like marked in the picture below.

Needed:

2x countersunk head wood screws with a diameter of 4mm. Choose the length you can find or have.

Drill

Doublesided tape

Installation (what I did):

• First place the Screw Blocks into the Hanger untill you get to the resistance but don't go further.

• Then place a small piece of double sided tape on the back side of the Screw Block.
• Take a water level and place it against the underside of the Hanger. Now place the hanger against the wall of choice and make sure the doublesided tape sticks.
• Now carefully push the hanger up (Note that the screw blocks stay in place) untill the screw holes come free but keep the Hanger partially on the Screw blocks. (look picture below)

• Now screw your screws into the Screw Blocks and push the Hanger down completely on the blocks. (Note: it helps to pre-drill your hole with a smaller diameter drill bit before screwing in your screws.)

  You should get something like this:

Installation is now complete :)

Happy printing!