Fastener Screw Organizer Shelf by MottN

MottN

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.24mm layer, 3 walls, 15% infill

Designer

9.1 h

2 plates

5.0(7)

Open in Bambu Studio

Boost

101

269

Released

Description

If you're like me and don't bother re-homing fasteners, you might end up with a bunch of these small parts organizers.

For a long time I just had a stack, but I made finally made a little shelf to hold them. I must say it is much nicer.

This shelf fits the organizers that are approximately 175mm x 100mm.
Each shelf is 5 units tall, and has features to be extendable with 2 m3 screws to secure the extension.

Print the base part, and then add to it with the extension part.

fastener assortment

fastener

screws and bolts tray

Comment & Rating (15)

@ajollylife

this project looks great, however I made the mistake of assuming that since all my boxes were the same size, but that was the size this was designed for and of course I didn't bother measuring before printing. it would be great if you made this parametric to make it for a bigger size, and maybe adding a little bit of material as a floor for each box so that way smaller boxes could still fit?

The designer has replied

@MottN.

Oh yeah sorry about that, and yes parametric would be a good idea and not too difficult. I will add it to the list. I had thought the size I had was the most common one, but maybe that's not the case...though I do have a couple smaller ones as well.