Beyblade X Bit - Dot

Remixed by

Beyblade X Bit - Dot

Remixed by
Boost
24
52
9

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Designer
26 min
1 plate
5.0(6)

Open in Bambu Studio
Boost
24
52
9
6
117
81
Released

Description

Sorry for the lack of posts! I was busy with things and wanted to make sure the old models are still up and running.

This is a Bit I never knew about till yesterday. This is the Dot Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

Disclaimer
This Bit has small details, so perhaps try a lower layer height, might work a bit better.

I printed this with ELEGOO Basic PLA White, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

 

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…


Credit to Juuni on Tinkercad.

Comment & Rating (9)

Please fill in your opinion
(0/5000)

great print, love it on my crest Leon (perchance hexa next)
The designer has replied
0
Reply
glad you like it! im trying to find a time to post hexa but i've been incredibly busy.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
As promised, simple but effective. perfect fit
0
Reply
ball high needle hexa orb
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
No more