NOTE: V2 (for 13x3mm magnets) has been added to the newest profile, which also includes V1 with optimized seam placement for a better looking print! Please use the new profile for both V1 and V2 prints.

New profile added for 10x4mm magnet version.

Ultimate? That's a pretty big word to use when there's so many other designs, right? But print one, and I think you'll agree!

If you're doing huge multi-color prints with 1000+ filament changes, this should be fine for you! If you don't need this large of a bin, check out https://makerworld.com/en/models/841359#profileId-787594 for my Small version!

I needed a large, low profile bucket that attaches firmly, but easily to the printer, not sitting behind it or jutting out the side. My space is limited, and with two printers on one small surface (with the anti-vibration feet, of course), they dance around quite a lot… maybe you're in the same boat?

This is very easy to print:

• Standard PLA, .020mm layer height, no supports needed!
• I've added two small built-in supports to support the wing overhang, that snip right off.
• This bucket has 1313 cm² of volume to the bottom of the chute opening (more than double my small version).
• Glue in qty. 8 10x2 magnets, and you're ready to rock!
• Prints in about 4 hours hours and uses 181g of filament.
• Integrated vent holes to allow airflow through the rear panel vent. 

Snaps in place easily and firmly, these will not fall off when your printer is going crazy! You can even easily install it blind if you cant quite see behind your printers. It holds plenty of poop, and you can easily see if it's getting full from any angle from the back or sides.

Enjoy!

V2 Updates:

• V2 adds a 13x3mm magnet version to the profile. 
• Profile includes V1 and V2 models. 
• Optimized seam location for V1 model, no other changes.