Hair Tie Organizer

Hair Tie Organizer

Boost
30
61
7

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
H2D

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
Designer
4.2 h
1 plate
4.5(4)

Open in Bambu Studio
Boost
30
61
7
3
31
20
Released

Description

Hair tie and bobby pin organizer. The extension can be put on either side or duplicated for both sides.

Comment & Rating (7)

(0/5000)

This printed out really well. The hole for the extension can double as a brush/comb holder too. Really like this. I think it would be nice if the base had a little lip so it could double as a tray for smaller clips and other hair accessories that don't fit on the main parts
The designer has replied
1
Reply
That's not a bad idea! I will make a revision with the bottom as a tray! Thanks for the feed back :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
There should be two attachments. There isn’t enough room for clips.
0
Reply
Thats a good suggestion. But not a good reason to give the print profile a 3 star rating..
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.