Back Story

Been wanting to do this bookmark set to accompany the few prints I already have of “The Attack on Titan” prints I've already done. I didn't know how to use editing software and such. Just starting to learn the basics. Will most likely do sets of portraits and bookmarks going forward of a certain subject. I may end up doing something that has already been done as we all are using same images that are readily available. The pictured shown - I was using a silk PLA. Any white should suffice. Mistakenly left the silk in the AMS. A pleasant mistake. I like it so much, I'll print the other half set on it. Was using a Mika3d silk white OEM PLA I got from Amazon to print Ornaments…just if you are wondering. I will be starting a Patreon page if you are interested in commercial use. Give me a message if you are interested.

Attack on Titan Poses #2 Bookmark Set
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Can be resized by adjusting the x and y axis but leave the z axis at 100%. Stringing may occur with Hueforge, just use a lighter to whisk them away.

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.4
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #11 (0.96mm) swap to Orange
At layer #14 (1.2mm) swap to Jade White for the rest.

To become an Authorized Seller of any of my works, please visit my Patreon page to obtain a Merchant License. https://www.patreon.com/3djdprints