Filament Guide Fix angle for the Sovol SH02

Remixed by

Filament Guide Fix angle for the Sovol SH02

Remixed by
Boost
12
21
10

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
57 min
1 plate
5.0(9)

Open in Bambu Studio
Boost
12
21
10
4
38
19
Released

Description

SETTINGS FOR BAMBU PRINTERS

 

This is a fix to the sharp angle in the Comgrow/Sovol SH02 Filament Dryer Box. The factory guide would cause excess bends and jams causing failed prints unable to pull form the box. This puts it more of a vertical instead of a parallel feed function eliminating the strain.

 

Uses the factory screw, nut, and rubber seal to maintain all tight.

 

Print with high temp filament such as ABS/ASA/PETG because the inside does get up to 70C.

 

Can insert a PTFE tube on both sides or not. The inside hole is beveled so no sharp edges.

 

 

Bill of Materials

Bambu Filaments
B00-K0-1.75-1000-SPLFREE
× 1
B01-K0-1.75-1000-SPL
× 1
G02-K0-1.75-1000-SPLFREE
× 1
B50-K0-1.75-1000-SPL
× 1
Buy Now
Download BOM

Comment & Rating (10)

Please fill in your opinion
(0/5000)

Printed perfectly with ABS
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
works as described! printed on PETG Pro
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed without issue, fits well
Show original
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply