NOTE: V2 has been added to the newest profile, which also includes V1 with optimized seam placement for a better looking print! Please use the new profile for both V1 and V2 prints.

Ultimate? That's a pretty big word to use when there's so many other designs, right? But print one, and I think you'll agree! 

If you're doing huge multi-color prints with 1000+ filament changes, this may be too small for you; see https://makerworld.com/en/models/846779#profileId-794010 for my Large version!

I needed a small, low profile bucket that attached firmly, but easily to the printer, not sitting behind it or jutting out the side. My space is limited, and with two printers on one small surface (with the anti-vibration feet, of course), they dance around quite a lot… maybe you're in the same boat? 

Snaps in place easily and firmly, these will not fall off when your printer is going crazy! You can even easily install it blind if you cant quite see behind your printers. It holds plenty of poop, and you can easily see if it's getting full from any angle from the back or sides.

Enjoy!

V2 Updates:

• Prints 6 minutes faster than V1 and uses 2g less filament. 
• Now 5mm deeper to match the depth of my large bucket design, which adds an additional 53 cm² of volume, bringing the total volume to the bottom of the chute opening to 701 cm².
• Bottom layer reduced thickness by .5mm to save filament. 
• Enlarged BL logo, now matches my large version.
• The back wall is now smooth internally where the filament would hit, to avoid filament poops potentially hanging on the slits. I haven't had an issue with this, but some users were concerned. The small slits on the back edges were left in place for aesthetics and so you can see the level from the back if needed. 
• No physical changes to V1, just optimized seam locations for a cleaner print. 

V1 Original: 

This is very easy to print:

• Standard PLA, .020mm layer height, no supports needed! 
• I've added two small built-in supports to support the wing overhang, that snip right off. 
• This bucket has 648 cm² of volume to the bottom of the chute opening.
• Glue in qty. 8 10x2 magnets, and you're ready to rock! 
• Prints in less than 3 hours and uses about 110g of filament.