Difficult to print the head. Too thin there and was trying manual support but not possible since it got a bottom. Maybe bad settings

Excellent result, although it didn't fully close in a few places

Printed great and looks good with translucent sparkle PLA, but I can't insert a light or use the threaded cover. The bottom is solid, though there's a threaded ring piece. It seems like the model should be open on the bottom. Am I doing something wrong that's causing it to fill in? I'm also getting an odd vertical pattern that's visible with the translucent filament. Any suggestions on a different infill pattern that might look better or some other setting that would help?

The angel itself is super cute and my family loves it. But I have big issues with the bottom plate on my A1 mini like shown on the photos. Since I don't need them anyway, I didn't reduce to much stars for it. I also have issues with the head. Each print shows some smaller holes on the top which luckily aren't too visible from distance. Despite my issues, it is a really great Christmas print and a great present for the (grand-) parents!

Hello, they are perfect, the only problem is that as I am new to this I don't know how to insert the candles inside the Angel

I have now the second time spaghetti. Looks like the one wall was missed one time and then everything goes away. But it's also possible, that the room temperature (15-17°C) is too low for that printing. Other prints (Litophane Xmas LED Lights) were successful & the plate was also cleaned with Isopropanol.

Seems good but if you hang it somewhere you cannot put led light in it ? Should make a bottom that would be possible to open and close once you got a tea light in it.

had issues with my first attempt, washed my plate and it turned out excellent!

It's very nice, but the crown of the head doesn't print well