This is a candle light holder for standard candles that are around 22-24mm in diameter normally, with a slightly coned end to fit in various holders.

The holder consists of two parts printed on the same plate:

• Candle light holder (the “rope”).
• Drip catcher (where the candle is mounted).

This holder works for both real candles and LED candles.

When using real candles, make sure to use a “Candle light snuffer” of the type that I´m linking below:

4pcs Automatic Light Extinguisher, Light Stopper Automatic Light Snuffer Ring, Automatic Fire Extinguisher for Safe Extinguishing Candle Flame, Candle Accessories Tools Light Care Kit (Gold : Amazon.se: Home & Kitchen

In the unlikely event that the snuffer would not work, as extra security, you can fill the drip catcher with water. The water will put out the candle when it reaches the water. As a rule, you should never leave candles unattended.

I use “Fuzzy skin” to make the surface look more organic and alive (so to speak).

The other reason is to hide the seam in the drip catcher.

If you print this without “Fuzzy skin”, remember that 0.3mm of material disappears from all walls meaning that holes get bigger.

Prints easy in PLA or PETG without supports.

No supports.

No assembly (except putting the candle in of course).