Captain Hook (front door coat rack) by BigJon1378

BigJon1378

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

2.7 h

1 plate

4.0(3)

Open in Bambu Studio

Boost

Released

Description

Assembly video linked at bottom! 😁

Don't be shy BOOST this guy!

I have a bad habit of misplacing my jackets when its time to leave the house. So I decided to make a nice little front door coat hanger so all my jackets are right there ready to throw on as i leave the house.

This makes a great addition to your front door during the holidays when its chilly outside and toasty inside, all your guests have a place to hang there coats and jackets while visiting for the holidays.

NOTES: This hook is intended to be used on front doors of your House it will work on bedroom doors but will not be as tight of a fit on the door itself.

The supports can be a little tricky to remove but do come off by hand without using tools, if you wish to use tools it will certainly make it that much easier. it also prints in 2 halves and has dovetail joints to join the 2 halves together, pay careful attention to the alignment of the joints when assembling it. You can use glue to bond them if you wish, but it is not needed just personal preference.

This model was printed using elegoo PLA black on my Bambu lab A1.

Thank you all for your continued support!

buymeacoffee.com/bigjon1378

Comment & Rating (8)

@user_1306346507

Print Profile

0.2mm layer, 3 walls, 15% infill

didn't fit together very well

The designer has replied

@BigJon1378

did you watch the video? also once it's on the door it's very sturdy.

@user_1306346507

Replying to @BigJon1378 :

I did watch the video. I also reprinted it with finer settings. same result.

@BigJon1378

it is a bit of a loose fit because of the tolerances is chose so it's easier to assemble. but once on a door it is very sturdy, I have hung a 20 pound suitcase from mine to test it's strength.

@user_3354012017

Print Profile

0.2mm layer, 3 walls, 15% infill

Great design!!

The designer has replied

@BigJon1378

thank you very much 😊

@shaival14

Print Profile

0.2mm layer, 3 walls, 15% infill

The designer has replied

@BigJon1378

thank you

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.