“CLICK” The Indexable Poop Chute allows quick and easy placement behind the printer without needing to guess the alignment with the poop chute! The back of our printers are hard to access or see so we made this poop chute with tabs that allow it to click into place.

Please note, this version is intended for AMS and external filament dryer users. It is tall and will interfere with filament spools mounted on the rear filament support.  A shorter version has been posted for “backpack” filament users:
https://makerworld.com/en/models/895882 

Key features:

• Index tabs to position the poop chute without any guesswork
• Inspection slots to see when it's time to empty
• Taller and wider than the usual for those lengthy multi color prints
• Large slots to accomodate a wide range of magnet sizes

Instructions:

• Print in just about any filament and profile you like best.
• No supports needed
• Use any magnet up to 6mmx12mmx12mm. Drop the magnet in the hole and use a drop of glue to keep it in place. Only a single 6x12mm magnet is needed but the extra holes can be useful if using smaller magnets where more might be needed.

Print Times:

• CLICK: 5:47 / 177g
• CLICK LE:  2:45 / 90g
• CLICK XL:  7:54 / 354g
• CLICK XL LE:  4:13 / 181g

12/1/24 Update:

1. Added an XL version for long multicolor prints.
2. Added Light Editions (LE) of both models for faster and cheaper printing.
3. Uploaded “CLICK Family” profile with all 4 models on separate plates and updated print settings.