200x200 Hueforge Frames x4 by Rusty Banana

Rusty Banana

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

7.4 h

4 plates

5.0(3)

Open in Bambu Studio

Boost

Released

Description

I've been asked to share these frames, so here they are. These frames can be printed in multicolor for a custom look and design as seen in my pictures. They hold 200x200 hueforges. (opening is 205x205) A little extra room if your printer is not dialed in for close tolerances. The frames all lock together on the back side easily and connect all 4 frames together. The hueforges stay in place with corner locks for faster print times, less filament and hold very tight. If the lock tab does not fit on one side please flip it over and it will fit just fine. I did not design the hueforges only the frames. Sorry to all the A1 mini users as this print will not fit on your board. I do have 150x150 frames under my profile. Please enjoy and let me see some of the artwork. Enjoy these frames.

multicolor hueforge frame

hanging frame frame

200x200 hueforge frame

Comment & Rating (17)

@krlosclemente89

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

I scaled it up slightly as my prints are 224, but they are fantastic, photos coming soon

The designer has replied

Show original

@Larry14

Glad it worked for you and thank you for 5 stars. Would love to see it when its finished.

@krlosclemente89

Boosted

Attached is a photo of the finished product; the bed's stars are barely visible, but it's a triumph 💯

(Edited)

Show original

@Larry14

Replying to @krlosclemente89 :

thanks for the pic. looks awesome

@mrskatv

Print Profile

0.2mm layer, 2 walls, 15% infill

I didn’t realize you have to print all four due to the partial beveling. Do you make a single frame (200x200)?

The designer has replied

@Larry14

Hello sorry for late response. yes these are a set and need all 4 to look right. I can post a 200x200 frame. I have lots I've been designing so please check back and I will get one posted soon. Thank you

@mrskatv

Finished the set of four for my kid’s Christmas gift (tribute to Jinx from Arcane). It turned out great using the textured plate.

@stormjmnorm

could you make the Harry Potter hueforge?? I saw it in the picture and was looking for it

The designer has replied

@Larry14

Hello I'm sorry I cannot as I am still learning how to do them. I found them all on makerworld. I only designed the frames.

@mrskatv

Here is a link to the Ravenclaw image. The same designer made all of them, so the others should be easy to find once you go to this one… https://makerworld.com/models/490454

@FAFO

Boosted

this is fantastic!! could you make a mini a1 size for their common 17cm by 17cm pictures?? thank you :))

The designer has replied

@Larry14

Hello thank you for the boost it's much appreciated. I have a 150x150 set on Makerworld as well. you could resize those to your liking just make sure you use the same percentage for the locks as u use for the frames. Thanks again