Transformers

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 140x200mm in size

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Transmission Distance: 4.5
PLA BambuLab Basic Blue Gray Transmission Distance: 6
PLA BambuLab Basic Orange Transmission Distance: 4
PLA BambuLab Basic Beige Transmission Distance: 4.5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Gray Transmission Distance: 7
PLA Kexcelled Sky Blue Transmission Distance: 5.1
PLA BambuLab Basic Jade White Transmission Distance: 4.5
This print uses 9 unique filaments

Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Blue
At layer #15 (1.28mm) swap to Blue Gray
At layer #16 (1.36mm) swap to Orange
At layer #20 (1.68mm) swap to Beige
At layer #21 (1.76mm) swap to Yellow
At layer #24 (2.0mm) swap to Gray
At layer #26 (2.16mm) swap to Blue
At layer #29 (2.4mm) swap to Beige
At layer #31 (2.56mm) swap to Sky Blue
At layer #25 (2.64mm) swap to Jade White for the rest.

*Two optional frames possible (use the one for 140mm X 200mm)

- One with the hueforge inserted from the front without losing the outline border (but the border frame seems smaller)
https://makerworld.com/en/models/689118#profileId-617795

- The second with the hueforge inserted from the back with a loss of less than 1mm on all sides of the image (border a little bigger than the first)
https://makerworld.com/en/models/689107#profileId-617786