Beyblade X Bit - Disk Ball

Remixed by

Beyblade X Bit - Disk Ball

Remixed by
Boost
34
56
13

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Designer
34 min
1 plate
4.3(9)

Open in Bambu Studio
Boost
34
56
13
4
213
133
Released

Description

The Disk Ball Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

I printed this with ELEGOO Basic PLA White, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

 

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…


Credit to Juuni on Tinkercad.

 


Comment & Rating (13)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
very useful
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Strength Issue:was battling with it and it broke like snapped in half
The designer has replied
0
Reply
Would you mind sending a picture if you did not throw it out yet?
0
Reply
Replying to @Agent_9 :
here
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
love being able to print these bits
0
Reply
ball high needle hexa orb
0
Reply
Amazing!! :D
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply