Cool looking Hueforge.

READ BEFORE PRINTING:

This Hueforge may be a bit diffrent to others. You need to change the color 6 Times. AND you start with BLUE. The Silk PLA that I used for the Hair does a great shiny effect.

Filaments that I used:

-Teqstone Sky Blue Silk pla (great shiny effect for the Hair)

-Esun Black

-Esun Orange

-Esun Yellow

-Bambu Ash Grey

-Bambu White

I added a Print with 6 AMS Slots, just Breaks without AMS and normal 4 Slot AMS. (Read the Buildplate Names)

If you use the 4 Slot AMS you have to change the Filaments after you are done with Blue and Black.

Change the Slot 1 (Blue) to Yellow and Slot 2 (Black) to White)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 97.14x170mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Start with Blue

Swap at layer #10 to Black

Swap at layer #11 to Orange

Swap at layer #15 to Ash Grey

Swap at layer #18 to Yellow

Swap at layer #21 to White

Boost ,like and/or Comment would be nice :)