Custom Beyblade Bit - High Gear Flat

Custom Beyblade Bit - High Gear Flat

Boost
27
31
7

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Designer
29 min
1 plate
5.0(4)

Open in Bambu Studio
Boost
27
31
7
1
57
38
Released

Description

You guys thought I'd only do one Bit? This is the High Gear Flat Bit, made by me! Its compatible with any Beyblade from the Beyblade X line.
Its tall this time

Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

I printed this with ELEGOO Basic PLA White, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

 

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…

Also, sorry about the App Icon image, it might be inverted and I can't figure out why, probably just a glitch tho!

Comment & Rating (7)

Please fill in your opinion
(0/5000)

its amazing
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
goofy ahh beyblade bit 💀
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
aggressive
0
Reply
ball high needle hexa orb
0
Reply
Works amazing you are so good at 3D modeling!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
No more