IMPORTANT: There is an updated version here: https://makerworld.com/en/models/1082667

Very simple and quick to print stand for your washed building plates to dry on.

Features:

• minimal contact surface to let the out asap
• water drain between feets
• 10-degree angle allowing water to go down and dry asap
• three plates stands to dry simultaneously

When I recently started to use A1 Mini, I quickly realised how important it is to clean building plates between prints, especially prior to sophisticated prints with extremely low or extremely big plate contact surfaces. Cleaning lets avoid wrappings of big contact surface models and lets the material stick properly without a brim when the contact areas are small and disconnected. I am using regular dishwashing liquid for that in the sink and then put plates on this model to dry out.