Beyblade X Bit - Elevate Remixed by Agent-9

Remixed by

Agent-9

Toys & Games>Other Toys & Games

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill, Tree (Auto)

Designer

26 min

1 plate

3.3(3)

Open in Bambu Studio

Boost

176

Released

Description

The Elevate Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

I printed this with ELEGOO Basic PLA Sky Blue, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…

Credit to Juuni on Tinkercad.

Boost Me (for free)

Boost me if you would like!

beyblade x

beyblade

Comment & Rating (8)

@ZamanDesignZ

unfortunately because of the way the bit is oriented for printing and lack of support the bit doesnt print as intended i just printed 2 and it came out messy would just using tree supports for the print

(Edited)

The designer has replied

@Agent_9

You were using tree auto supports correct? Just those supports should be sufficient, and the orientation should be the way shown in the image (Gears facing the sky). You could also try to auto bed level or full bed level your printer, or flow calibration. Besides that it may be your printers' settings.

@user_2998965069

Print Profile

0.2mm layer, 2 walls, 15% infill, Tree (Auto)

I've tried twice, but from a certain point it just starts producing nonsense and cancels the print

The designer has replied

Show original

@Agent_9

I'm sorry to hear that I suspect this is intended, as it has low burst resistance unless you mean pressure It could also be a problem with your settings If you could send me a picture of the bit, that would be helpful, along with the printer you are using, I could try to help

Show original