Beyblade X Bit - Cyclone

Remixed by

Beyblade X Bit - Cyclone

Remixed by
Boost
21
46
5

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Designer
24 min
1 plate
5.0(3)

Open in Bambu Studio
Boost
21
46
5
2
118
60
Released

Description

The Cyclone Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

I printed this with ELEGOO Basic PLA Sky Blue, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

 

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…


Credit to Juuni on Tinkercad.
 

Boost Me (for free)

Boost me if you would like!

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Best tip ever! So fast and really good attack type!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
super
0
Reply
ball high needle hexa orb
0
Reply
PLZ MAKE MORE!!!!! these belong in a museum
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
No more