This is a model of a cozy half-timbered Christmas house, including two christmas trees and a sled to insert some candy. You can lighten it up with the use of the LED Kit-001, it will fit in the cutouts of the main building. Of course some LED candles will achieve the same results :)

This model is created by myself and inspirated of old wooden models made of cutted wood sheets which have to glued in place. So also for this model you will need glue for some parts.

You will need only max 10-15 Minutes to get it ready, so it can be a funny work also with kids. But keep an eye if you use special glues like super glue - use an heat glue gun for better work with the kids.

Please use my uploaded print settings, I invested lots of hours to find the best settings for you :)

----

You will need some glue to fix all parts, especially for the roof parts. I've made some glue marks on some parts and some also don't need to be glued. Also it is very important that your printer and the used filament is correctly set up so that the parts fit in the correct counterparts. Use the calibration if you have problems!

Follow this order:

1. Push the wooden frames into the front walls, use glue if it doesn't fit snug inside the counter part

   

    

2. Assemble the decoration parts of the sled and the trees, you will need glue here. Also insert the back building part inside the base.

   

    

3. Assemble and glue the front part of the building to the back part.

   

    

4. After that repeat this for the upper floor, glue is important.

   

    

5. Glue the roof on the truss, keep an eye that it is correctly centered

   

    

6. Glue the roof decoration, also you can optional glue the trees and the sled, but it also would stay in the wholes of the base

   

Have fun and Merry Christmas :)

Thanks :)