Antonov AN-124 1:400

Remixed by
Copyright Claim

Antonov AN-124 1:400

Remixed by
Boost
17
30
3

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
4.7(3)

Open in Bambu Studio
Boost
17
30
3
6
64
28
Released

Description

Remixed from a wonderful 1:200 scale model on Thingiverse. Separate parts were joined, shrunk to 1:400, simplified, then resplit for easier printing with less seams.

 

Model uses dowels to connect the parts. Glue is necessary as I set tolerances a little high - a previous model I built was too tight (and so I think I went too far), but nothing glue couldn't fix. With tight enough tolerances, you may not need glue. Two sets of dowels: smaller (x3) connect the two halves of the main fuselage, larger (x2 each, x4 total) connect the front and tail sections to the main fuselage.

 

I encountered errors (non-manifold edges) on the original stl which I think I managed to somehow make disappear. If you encounter them, it should still print successfully as I was able to. 

 

(Son loves airplanes and is making me make everything in 1:400 scale - pictured model is his coloring with acrylic markers.)

 

If you liked this print, please check out my other 1:400 prints.  Feedback, thumbs up, and/or boosts would be very appreciated!  Thank you!

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
The pegs are a little too big.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in PLA
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more