Xmas Tree Piston Launcher
IP Report
Xmas Tree Piston Launcher
Boost
29
47
4
GIF
Print Profile(2)
0.28mm layer, 2 walls, 15% infill
Designer
4.3 h
2 plates
0.28mm layer, 2 walls, 15% infill
Designer
5.6 h
5 plates
Open in Bambu Studio
Boost
29
47
4
0
54
51
Released
Description
Piston launcher, that can launch an xmas tree ;-)
Launch angle adjustable!
Things to take note:
- Do not enable support when printing the tree.
- Must use 0.28 layer height for the tree.
- You will need some effort to press the tube into its base. It is tight so can air seal better.
Comment & Rating (4)