Beyblade X Bit - Ball

Beyblade X Bit - Ball

Boost
22
39
12

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Designer
24 min
1 plate
4.0(4)

Open in Bambu Studio
Boost
22
39
12
2
80
39
Released

Description

The Ball Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

I printed this with ELEGOO Basic PLA White, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).


Credit to Juuni on Tinkercad.

Boost Me (for free)

Boost me if you would like!

Comment & Rating (12)

Please fill in your opinion
(0/5000)

not so good I tried to make it on my A1 mini and it fell apart
The designer has replied
0
Reply
How exactly did it fall apart? Did you change any of the settings, such as infill?
0
Reply
Replying to @Agent_9 :
as I got to the top my printer glitched out and started printing spaghetti
0
Reply
ball high needle hexa orb
The designer has replied
0
Reply
No need to spam on all models! I can see the comment. I've already made ball, did you mean something else? As for the others, I'm hoping to post them soon.
0
Reply
Replying to @Agent_9 :
k thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
good print used it quite a bit
0
Reply
sorry just realised you had ball
0
Reply
definitely recommend printing! amazing!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Strength Issue:did not print fully
Support Issue:printed spaghetti
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
0
Reply
No more