Owl Wind Spinner by D.Newman

D.Newman

Household>Decor

IP Report

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

H2D

0.15mm layer, 2 walls, 5% infill

Designer

3.3 h

2 plates

4.9(17)

Open in Bambu Studio

Boost

108

181

222

165

Released

Description

Flying Owl Spinner, I used fishing line threading it from top to bottom through all holes and tying to plumb bob. Seperated on two plates for different colors.

Layer Height: .15

Infill: 5% on everything but but plumb bob, 100% infill on plumb.

Comment & Rating (19)

@AdVanceYourself

Print Profile

0.15mm layer, 2 walls, 5% infill

This printed great! Slicer said the small white ring may cause collisions but that didn't happen. Line holes are perfect. now to find the best place to hang it up!

@D.Newman

thank you for the review, happy it printed great for you!

@nealc10

Printed easily from PLA. (I had a lot more trouble when I extracted the STL and tried to print from PETG, though). Also tried to use nanocord for the string, but the hole size wasn't large enough, so went with fishing line.

(Edited)

@ChibbiBibi

Print Profile

0.15mm layer, 2 walls, 5% infill

easy print, a small piece broke off but was able to glue back in without any visible difference. also added a ring to attach Nikon on top to make it easier to hang.

(Edited)