Filament Poop Slide Chute by Yasiek

Yasiek

3D Printer>3D Printer Parts

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

5.8 h

3 plates

4.5(26)

Open in Bambu Studio

Boost

203

236

113

Released

Description

Tiny poop chute for Bambu P1S
2x M3x16 screw for clamp (in a place of 2 cover screws)

Made in PLA for better slide….

Boost Me (for free)

Do it and have nice day...

Comment & Rating (42)

@NavratilLubos00

Boosted

It works great and looks nice, thank you very much.

The designer has replied

@YasiekPL

thanks a lot for a com and boost. sometime poops sticks, but as I said tiny/narrow was a more important achievement in my case.

(Edited)

@YasiekPL

thanks a lot for the photos and comm. have nice day.

@Yobyvan

Print Profile

0.2mm layer, 3 walls, 15% infill

This was a great and simple design that perfectly fits the narrotable I had my printer staged at.

The designer has replied

@YasiekPL

thanks for photo, first except my own. I'm happy it's serve well. poo box is a bit locking because of curios cat 😉

(Edited)

@user_1468235950

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

@AresMars

Print Profile

0.2mm layer, 3 walls, 15% infill

The slide is far too loose on my print and the marbles often don't slide down Printing the parts, however, went quite well

The designer has replied

Show original

@YasiekPL

so there is the gap on top for it, but if your filament poops are to big, it's other problem. next level will poops jumping out inside printer.

@YasiekPL

https://makerworld.com/models/105902 think about it....

@YasiekPL

hmm... but why ** for print profile, is something wrong with it?

@user_459741566

Print Profile

0.2mm layer, 3 walls, 15% infill

great print

The designer has replied

@YasiekPL

thank you, and let it serve well...

@Sephiroth_Chan

Print Profile

0.2mm layer, 3 walls, 15% infill

It's okay, sometimes things get stuck

The designer has replied

Show original

@YasiekPL

because it's tinny versiom, more important was a place on the desk than wide width. but in case of stuck top gap helps. in my case trouble was only when filament was pulled out from the "bucket". some one made cover for it.... post above this is the link

(Edited)