This is a gift box with sides that hinge down flat when opened.

I have a version with no bow, if you would prefer, which you can find here:  https://makerworld.com/en/models/803216#profileId-743442

I've prepared many build plates so you have a selection of sizes to choose from and you can print them straight from the app without having to edit them yourself.

The box itself all prints in one color, which is great if you like saving on waste.

The lid has 2 options for each size. One with the ribbon and bow, and one just with the bow. The ribbon and bow will print layer by layer and does create a fair amount of waste and take a long time, so I've included the option without the ribbon which prints object by object and minimises on waste and print time.

The bow prints with supports and on the larger sizes will pop right into place without any glue. On the smaller sizes you will likely need to glue the bow in place.

I've tested this down to 40% of the original size (X Small), and I wouldn't want to go any smaller. It worked first time but I was a little worried I would snap the hinges.  At this size you will definitely need to glue the bow on too.

These are the sizes of the bases without the lid:

• X Large: 11.1cm square base, 8cm high (slightly shorted in proportion to the others due to build plate size restrictions)
• Large: 9.4cm square base, 7.1cm high
• Medium: 7.8cm square base, 5.85cm high
• Small: 6.1cm square base, 4.6cm high
• X Small: 4.4cm square based, 3.4cm high

I’ve had a lot of questions from people asking if they can get a license to sell my designs commercially. I’ve set up a Patreon for those who wish to. PrintWorthyUK | Patreon.