Here's a fun new twist on a classic board game! Introducing Battle Strip!

The rules for game play are the same as the original, with the only addition being to make sure the pieces on your board match what's on your person. As the name implies, as the pieces get “sunk” and taken off of the board… make sure your board matches your person!

If you already have the original board game, you can just scale the pieces to fit. I made the pegs on the pieces 10mm apart, center to center, and rounded the pegs to make them universal. Hopefully that helps make the scaling simple. I also designed 3 variations of the pegs for you to choose from, so I did not include a plate with the appropriate number. You might also be able to use these from the original game.

DO NOT ENABLE SUPPORT

Otherwise you might be spending a lot of time digging out support filament from these tiny holes. The only exception is the Ball Cap needs support since it has a bill. Make sure to orient it with the bill up so that it does not add support inside the holes.

You can print most of this with .4mm nozzle. You will want a .2mm for the bra, I have added its own profile for that. If you print all of the pieces in .2mm, you might be able to see some of the details on them, but on a textured bed they didn't turn out quite as obvious as I was hoping.