Uno Wild Card 6x3 Magnet Slider Fidget

Remixed by
Copyright Claim

Uno Wild Card 6x3 Magnet Slider Fidget

Remixed by
Boost
3
7
0

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
2 plates

Open in Bambu Studio
Boost
3
7
0
0
1
1
Released

Description

Description

This is a fun magnet fidget slider that takes 6x3 magnets.

 

Magnetic Fidget Slider
Uses total of (12) 6x3mm magnets, 6 for each side.

I recommend N52 magnets for a stronger snap.

You can find the magnets I use here! https://amzn.to/3UMVZBe

 

Printing:

I recommend using stick glue on the plate for a firm foundation to counter print quality issues: https://amzn.to/3Z60SIj

0.2mm layer height for the housing

0.1mm layer heigt for the top plate for better quality, otherwise 0.2mm as well

no supports needed

I use these two PLA+ filaments for red, white, and blue: https://amzn.to/3Ctm8ij

I use the PLA+ green to complete the set: https://amzn.to/3O8LBQM

 

Assembly:

Glue the magnets to the housing, then glue the top plate on.

Repeat for other half of the slider, minding the magnets polarity.

For really good super glue that is cheap I recommend this! https://amzn.to/3YUHM6K

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more