Sovol SH2 or Comgrow SH02 Filament Dryer Riser Remixed by Sammniam2

Remixed by

Sammniam2

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

0.2mm layer, 2 walls, 15% infill

Designer

3 h

1 plate

5.0(18)

Open in Bambu Studio

Boost

130

Released

Description

Found a similar model for a slightly different Sovol drier (3D Dual Drier) that almost worked, but although they look similar sizes, they aren't. This model is tweaked to fit the footprint of either the Sovol SH02 or Comgrow SH02 dual roll filament driers. It's roughly 1" high, there is additional center supports as I realized 2 spools of filament weigh in at 2Kg or 4.40 lbs, so i wanted to be sure it was safe [I have 2 cats - if you have cats, then you will understand. Dogs too. Probably any small creature that runs around controlling your life :) You will understand].

I suggest printing in PETG or ABS (if you can), but if you have some PLA + or PLA Pro, that may work. You want heat resistance! No support needed, pretty straight print.

Comment & Rating (48)

@KYZDesign

Boosted

Works great, making a second one now. Boosts coming soon :)

The designer has replied

@sammniam2

Very nice, its good to see someone else w/ 2 of these dryers 😀

@KYZDesign

Boosted

Replying to @sammniam2 :

It’s much more versatile than having one Sunlu s4!

@sammniam2

Replying to @KYZDesign :

Yes, i had thought about that model then realized everything had to be 1 type inside at time. I want to cook my petg & pla at the same time 😆

@user_2988818463

Print Profile

0.2mm layer, 2 walls, 15% infill

printed and fit well

@sammniam2

very nice 👌

@cantbudgeit

Boosted

Fits perfectly, I printed it in Bambu matte PLA, I think it will be fine, but I'll let you know in a month

The designer has replied

@sammniam2

Hopefully it behaves :)

@Argalo

Hello!! How did the design turn out using PLA :)?

Show original

@cantbudgeit

Boosted

Replying to @Argalo :

It works just fine in PLA, no warping or anything. I think the heat is distributed so much better with the riser that the material doesn’t matter.

@user_3082380071

Boosted

Just the thing I'd been looking for to use with my SH02. Good job!

The designer has replied

@sammniam2

thanks 😊

@xvash21x

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Fits perfectly

@sammniam2

Thanks 😊

@xvash21x

Boosted

Thanks!

The designer has replied

@sammniam2

Thanks 😊

@irishpride114

Print Profile

0.2mm layer, 2 walls, 15% infill

Made 2 for each of my dryers. I would definitely print again if I buy another dryer.

@sammniam2

Glad they are helpful :)

@user_2702853214

Boosted

Perfect fit for my Sovol SH02 - I didn't even realise just how hot it was making the table, despite the silicone mat between them, until I lifted the SH02 to install it! Thanks for sharing this.

The designer has replied