Soda bottle water nozzle

Copyright Claim

Soda bottle water nozzle

Boost
0
4
4

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
3.0(1)

Open in Bambu Studio
Boost
0
4
4
1
7
3
Released

Description

Wanted a easier way to water my plants without having to poke holes in the bottlecap so I made this in fusion360. Printed on a Creality K1C.

Comment & Rating (4)

Please fill in your opinion
(0/5000)

The print profile is no longer public
This profile went much better!! The supports were a bit difficult to remove, mostly just the last ones at the tip of the nozzle. They came off the threads really well! There's still quite a bit of water seeping past the threads, but since these threads are intact I think some teflon tape could fill those gaps. Thanks for providing an updated profile!
The designer has replied
0
Reply
Yeah, since fusion didn't have a preset for bottle threads I had to make them custom by making a spiral which was harder to get tighter and snug xD
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:Definitely needs support. I didn't realize there wasn't support in the print profile and printed from the app, so only a small brim was on the model. Threads were stringy, a little bit of spaghetti in the middle, and the nozzle finish looks rough. I was able to thread it on a bottle and it did make a nice spray pattern. But leaked massively from the threads.
The designer has replied
0
Reply
I will take a look at it
0
Reply
No more