USB SSD DOCK FOR Mac Mini 2024

这是一个为mac mini 2024版设计的外接硬盘底座，支持18mm以下厚度的外接硬盘。我为其设计了独立的散热风道以及改变了开关方向，使其更容易使用。

This is an external hard drive dock designed for the mac mini 2024 version, which supports external hard drives with a thickness of less than 18mm.I designed an independent heat dissipation duct for it and changed the direction of the switch to make it easier to use.

I use BambuLab ABS-GF print the cover and PETG-HF Print the red part.

The assembly of the switch part is shown in the figure below：

如果遇到组装后，开关按钮顶住机器开关，无法正常开关的情况，可以使用砂纸或小刀将顶针稍微切短一点：

If the switch button presses against the machine switch after assembly and cannot be turned on and off normally, you can use sandpaper or a knife to cut the ejector pin a little shorter:

如果你担心硬盘的散热问题，也可以选择打印打孔版外壳，来获得更好的散热效果：

If you are concerned about the heat dissipation of the hard drive, you can also choose to print a perforated version of the shell to achieve better heat dissipation: