Perfect adorable Snowman decoration for Christmas or christmas gift. I used translucent PETG with two colors to create the beautiful combination. I used manual supports but one finger broke off with the supports and I had to solder it back on. Keep in mind what supports you use on vulnerable areas like the nose and fingers. Adjust supports and sizing as needed. I also did some light sanding under the hat since there was some drooping since I didn't have supports for it. If you can do light sanding in small areas it would likely be easier than supports all around it though. Stands on its own. I think I used a 30% Infill. Adjust the infill to make it more durable but it will cost more materials and time but will be less likely to break.