6x3 Magnet Slider Uno Card Fidget

Remixed by
Copyright Claim

6x3 Magnet Slider Uno Card Fidget

Remixed by
Boost
21
68
7

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
46 min
2 plates
5.0(2)

Open in Bambu Studio
Boost
21
68
7
5
43
26
Released

Description

This is a fun magnet fidget slider that takes 6x3 magnets.

 

Magnetic Fidget Slider
Uses total of (12) 6x3mm magnets, 6 for each side.

I recommend N52 magnets for a stronger snap.

You can find the magnets I use here!    https://amzn.to/3UMVZBe

 

Printing:

I recommend using stick glue on the plate for a firm foundation to counter print quality issues:    https://amzn.to/3Z60SIj

0.2mm layer height for the housing

0.1mm layer heigt for the top plate for better quality, otherwise 0.2mm as well

no supports needed

I use these two PLA+ filaments for red, white, and blue:    https://amzn.to/3Ctm8ij

I use the PLA+ green to complete the set:    https://amzn.to/3O8LBQM

 

Assembly:

Glue the magnets to the housing, then glue the top plate on.

Repeat for other half of the slider, minding the magnets polarity.

For really good super glue that is cheap I recommend this!    https://amzn.to/3YUHM6K

Comment & Rating (7)

Please fill in your opinion
(0/5000)

do you have files for the other UNO cards as well?
The designer has replied
0
Reply
no but I’ll make some over the next couple of weeks.
0
Reply
Replying to @Scrollhunter :
I just did the wild card one
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed exceptionally well and no issues
The designer has replied
0
Reply
Great!
0
Reply
Let me know if you guys have any problems.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more