Ryobi tracksaw track holder, print in place Remixed by topxnbo

Remixed by

topxnbo

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.1 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

adapted 3DDIY's design from https://www.thingiverse.com/thing:4571944

adjusted to fit my ryobi tracksaw tracks, with a total length of 165mm (very tight fit, my track measured 163mm after trimming the splinter guards), and a thickness of 11mm

Printed with bambu strength profile, which seems strong enough for me. tolerance worked with some generic PLA i have lying around. needed to use some thin metal ruler to pry open the nut, and once it's loose, it works perfectly.

Comment & Rating (3)

@melvinrooter

Print Profile

0.2mm layer, 2 walls, 15% infill

Print came off the plate looking very good. For a minute there, I thought something had gone wrong, because it takes a little bit of effort to break the cam free. Once you get a razor blade between the two pieces and sever them, the cam spins as it should. Perfect fit for my track; nice robust piece. Good remix, and a good original design from Dave Miao.