8x4mm Pucks for Budwin's DeadPool & Wolverine Mask by LB3D

LB3D

Hobby & DIY>Other Hobby & DIY

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.24mm layer, 2 walls, 15% infill

Designer

17 min

1 plate

5.0(8)

Open in Bambu Studio

Boost

Released

Description

This item is specifically for Budwin's Masks. I've used it on DeadPool & Wolverine. Not sure about the others but if it requires an 8x2mm magnet, it'll most likely work.

Deadpool - https://makerworld.com/en/models/606313?from=search#profileId-530132

Wolverine - https://makerworld.com/en/models/710044?from=search#profileId-640343

I created these “pucks” (25pcs) as an alternative to magnets for people who want to glue section or the entire helmet together instead. It worked well for me by giving a larger surface area for the glue. I did one with small pieces of double sided tape, so I have the option to pull them off and it worked great.

Enjoy!

Comment & Rating (16)

@Makos

Print Profile

0.24mm layer, 2 walls, 15% infill

perfecto

@Budwin3d

Boosted

Nice thinking brother.

The designer has replied

@LB3D

Thanks. Your stuff is just top notch. Thanks for all the hard work that went into your designs

@WondrousLaird

Boosted

how many are there

The designer has replied

@LB3D

There are 25pcs per run. thanks!

@LB3D

keep in mind that you will need half of the magnet count. Meaning if the helmet you're printing requires 50 magnets, you'll only need 25 of these.

@user_3495600781

Print Profile

0.24mm layer, 2 walls, 15% infill

They fit perfectly into the housings but must still be glued to the Budwin masks

The designer has replied

Show original

@LB3D

Yes, that's correct Another option I tried and worked well was using double-sided tape This allowed the mask to stay in place very well, but you still have the option of removing it if desired This was translated using Google, so I hope it was translated well Thank you

Show original