Can you elaborate what's not fitting? I have printed this case for 3 of those sensors and they all fit perfectly.

Hi my sensors are pretty much the same but the case just doesn't fit at all the holders are too long I guessed and the two halves just don't fit to each other I tried to put those halves together without the sensor but I couldn't close it and ripped the noses EDIT: apparently there are differences in thickness which varies with almost every batch by trimming down the sensor holder in the top part and making the hole larger helps fitting the sensor your print is exactly fitted to your sensor without room for bad manufacturing of the sensor there should be tolerances in board thickness the width was almost the same

Hey, i updated the sensor, reduced the size of the holding pins by about 1,2 mm - hope that is enough. You can find the new version here: https://makerworld.com/de/models/846431