I remade his modular-filament-drawer-system to fit on a bambu size printer.

and made it metric.

because i like his model so much but was bumbed out that it didnt fit a bambu size printer

i used:

• 18mm wooden sticks to support the spools you can make it any length ( i made mine 60cm wich fit 9 spools)
• 1 front plate that can fit a front panel ( screw holes are already there)
• 2 mid supports that can hold up the slider
• 1 back plate
• for screws i used 3x18mm but you can use bigger if you want
• drawer slider ( any size you want just make sure you put some extra mid section when you go very long. i used two mid sections for 60cm slider) 

you dont need the outer case because you can attach the drawer slider directly to a wooden wall( this way you can print it entirely from pla)  

please watch for instructions.