Tandem Mobi Alignment Disk by Poohstrnak

Poohstrnak

Tools>Medical Tools

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

1.1 h

1 plate

0.2mm layer, 3 walls, 15% infill

54 min

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

Was annoyed by my insulin pump sliding off the charger any time it vibrated. I had seen a couple of other models designed for this, but most of them had the cutout for the pump centered. I've always had an easier time getting the pump to charge ligning up the logos, as Tandem recommends. So I made this alignment disk to hold the pump in the proper position.

Hope someone besides me finds this useful!

Comment & Rating (10)

@user_2218385332

Printed well on my Creality K1. Printed it at a 90 degree angle so that the circle was vertical and the support was easy to remove

The designer has replied

@CJWTX

interesting. that didn’t occur to me. I just printed with a PETG interface and it was fairly simple to remove. figured it would be sturdier printing flat

@user_1913356493

printed well on my P1S. works perfectly for my charger. it does not fit snugly though I think this was apart of the design. Though you can free spin the design on top of the charger. I don’t see it affecting anything though unless you have a lot of clutter around your pump charger.

The designer has replied

@CJWTX

yes, that was intentional. I wanted to be able to rotate the plate to have the plug coming out at whatever angle was most convenient, and still have the pump sitting straight. hope you enjoy it!