Multiboard to IKEA Skådis adapter

Remixed by
Copyright Claim

Multiboard to IKEA Skådis adapter

Remixed by
Boost
24
83
7

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
5.0(4)

Open in Bambu Studio
Boost
24
83
7
4
46
24
Released

Description

This is a basic remix of the official 8 mm - Dual Offset Snaps (DS Part A) from Multiboard.io and part of this project https://dragonmountaindesign.com/2024/05/27/handheld-skadis-mount-vol-iii/ - just the hook. It's a tight fit to get the adapter into the multiboard, but it fits ok into the Skadis board. Notice that it only fits into multiboards every 1st and 9th hole, as shown in the image of the printed model.

 

The remix is done using the hook from the handheld-skadis-mount-vol-iii project, trimming it and merging it with the unmodified 8 mm - Dual Offset Snaps (DS Part A) from multiboard.o in FreeCAD.

 

All credits go to the original authors. I've tried to comply with the original licenses, but please notify me if this is not correct.

Comment & Rating (7)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
saved me tremendous pain adapting my multiboard tiles to my SKÅDIS. Snaps into place and seems to hold everything up even under load.
The designer has replied
1
Reply
😎👍And I like your setup :-)
0
Reply
I have been searching for this for a long time. Thank you
The designer has replied
Show original
1
Reply
Nice to hear :-) Thank you as well :-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more