Roman Pantheon inspired Self-watering planter

Copyright Claim

Roman Pantheon inspired Self-watering planter

Boost
20
46
1

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.2mm layer, fuzzy skin 0.2 mm, no supports needed
0.2mm layer, fuzzy skin 0.2 mm, no supports needed
Designer
25.7 h
3 plates
5.0(1)

Open in Bambu Studio
Boost
20
46
1
1
23
5
Released

Description

I have quite a problem with overwatering so this is my solution for the problem. The area underneath the roof differs from the Pantheon, but the rest is in scale with the real thing.

 

Don't be discouraged by the long print time. 3 different versions are in that print profile: self-watering (full roof and with hole) and normal planter.

 

I recommend using marble PLA with 0.2 mm (thickness and point distance) fuzzy skin. It gives it a nice texture and almost completely hides the layer lines.

 

Planting:

Use clay pebbles as a base layer around 2 cm high. Then plant on top. I used some gravel to fill the porch underneath the roof.

Clay pebbles example: https://rb.gy/8uzhid

 

Watering:

Water through the roof or from the side (2 versions). When water goes over the little well and starts filling it, stop watering to prevent spillage. Water once a week or when empty.

 

I have been using the planter for the better part of a year and had zero leaks.

 

Disclaimer: Cat is not printable.

Comment & Rating (1)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, fuzzy skin 0.2 mm, no supports needed
0
Reply
No more