A free-form cubic lamp. Done in an Old factory style

Two different bases can be used here to support different light sources:

1- E14 Socket, Bulb, and plug

2- Puck Led (5V) (see Bambu Led Kit001)

185 mm height x 150 mm Width

Basic:

• Print 2 of each of the walls and 1 each of the base, shade, and top.
• Use supports for the 2 shorter wall pieces. from baseplate only, to support the wall connector pieces.
• Melt 2 x M3 Inserts into the bottom and top bar of each wall.
• Attach the walls to each other. The circular connections are tight, so work them into each other gradually to loosen them a bit.

Basic Parts

2-4 x M3 by 8 and 4 M3 by 10 screws

https://de.aliexpress.com/item/32443118299.html?

8 x M3 Inserts

https://www.amazon.de/dp/B08BCRZZS3?

For The E14 Model:

1- Run the cable through the base, attach the cable and switch wire to the socket and turn the socket into the base plate. Then attach the base plate using 2 to 4 M3 x 8mm screws

2- Slide the lamp shade cover into the 4-wall frame and attach the lid wit the M3 by 10 mm screws

The fassung-lamp socket ( e14-28 mm):
https://www.amazon.de/dp/B097K4YNL9

The electrical cable and switch:
https://www.amazon.de/dp/B002DAOX58

The E14 Bulb used here:
https://www.amazon.de/dp/B0B5MPL9MX

For The Puck Led (Bambu Kit001):

1- Run the cable from the puck led lamp through the base.

2 - Then attach the base plate using 2 to 4 M3 x 8mm screws

3- Attach the collar, twists on to keep puck led in place

2- Slide the lamp shade cover into the 4-wall frame and attach the lid wit the M3 by 10 mm screws

Printing :

The slicer settings for the base and lid:

.20 mm Standard

(All standard settings and speeds, Aligned seam settings)

Filament:   Eryone Matte Black PLA

The slicer settings for the 4 walls

.20 mm Standard

(All standard settings and speeds, Aligned seam settings)

(Supports required for (2) shorter wall pieces)

Filament:    Eryone Matte Black PLA

The slicer settings for The Shade:

Filament:  Sunlu Meta Cream White

.20 mm High Quality and Generic PLA
Infill % - 100 , Rectangular
Wall Loops - 8
Top Shell - 8
Bottom Shell - 6
Outer Wall Speed - 60 mm/s
Inner Wall - 150 mm/s

Seam Position- Aligned